logout
quit
show [chassis]
Example 2: The following example shows the help command for the blade:
MPX200 <1>#> help
admin [begin | end | start | stop | cancel]
beacon [ on | off ]
date [MMDDhhmmCCYY]
clear [logs | stats]
exit
fru [restore | save]
help
history
image [cleanup | list | unpack]
image cleanup
image list
image unpack [<filename>]
initiator [add | mod | run]
logout
lunmask [add | rm]
passwd
ping
quit
reboot
reset [factory | mappings]
save [capture | logs | traces]
set [alias | chap | chassis | fc | features | iscsi | isns | mgmt |
ntp | properties | snmp | system | vpgroups]
set alias
set chap
set chassis
set fc [<PORT_NUM>]
set features
set iscsi [<PORT_NUM>]
set isns
set mgmt
set ntp
set properties
set snmp [trap_destinations [<DEST_NUM>]]
set system
set vpgroups [vpgroup index]
show [chap | chassis | fc | features | initiators |
initiators_lunmask | iscsi | isns | logs | luninfo |
luns | lunmask | memory | mgmt | ntp | perf |
presented targets | properties | snmp | stats |
system | targets | vpgroups]
show chap
show chassis
show fc [<PORT_NUM>]
show features
show initiators [fc | iscsi]
show initiators_lunmask
show iscsi [<PORT_NUM>]
show isns
show logs [<ENTRIES>]
show luninfo
show luns
show lunmask
show memory
Command referencecommand reference148
To Next Page
Loading...
