HP StorageWorks 6100 - Enterprise Virtual Array User Manual

1. Modify the initiator name:
# vi /etc/<initiatorname>.iscsi
2. To configure the initiator and targets, start the iSCSI initiator applet (located in the YaST Control
Center under Network Services), and then set the initiator to start at boot time (Figure 44).
Figure 44 Configure the iSCSI initiator and targets
.
3. Select the Discovered Targets tab and enter the iSCSI target IP address (Figure 45).
Figure 45 Discovered Targets tab
.
MPX200 Multifunction Router 67

HP StorageWorks 6100 - Enterprise Virtual Array Specifications

General

Brand	HP
Model	StorageWorks 6100 - Enterprise Virtual Array
Category	Storage
Language	English