6. Install the HP StorageWorks MPX200 bezel:
a. Remove the four 10-32 x 3/8 in. screws that secure the rack rails to the front of the rack.
b. Position the bezel support plate in front of the MPX200 chassis, with the arrows pointing
up.
c. Replace the four 10-32 x 3/8 in. screws, two on each side of the bezel support plate.
d. Install the bezel by pushing it through the white pop-in tabs on the bezel support plate (Figure
11).
3. Bracket arrows1. Screw, panhead, 10-32 x 3/8 in.
4. Bezel2. Bezel mount bracket
Figure 11 Bezel view
.
Installing the MPX20032
To Next Page
Loading...
