To set the array bandwidth:
1. On the Information page of the selected array, click Array Bandwidth, and then click one of the
following values:
• Slow (50 MB/s)
• Medium (200 MB/s)
• Fast (1600 MB/s)
• Throttle
2. If you select Throttle, enter a value between 1 and 400 in the User Defined Bandwidth (MB/s)
box. (Figure 93 shows an example.) By default, the MPX200 uses all available bandwidth.
Figure 93 Setting array bandwidth
.
3. To save your changes, click Save.
4. In the Security Check dialog box, enter the administrative password. (The default password is
migration.)
The mpx Manager displays an informative message indicating that the array properties have
changed.
5. Click OK to close the message box.
6. To apply the changes and update the window, click Refresh.
Setting array properties in the CLI
Follow these steps to change the array properties using the CLI. Note that all data migration operations
are authorized only to the migration administrator session, miguser. For more information, see
Miguser session.
1. Log in to the MPX200 as guest and enter the password.
MPX200 Multifunction Router 261
To Next Page
Loading...
Need help?
General