Miguser session
The miguser is the migration administrator session that has privileges to run CLI commands related to
the migration operations. The default password for starting the miguser session is migration. You can
start and stop a miguser session using the following commands:
miguser [start/begin]
miguser [end/cancel/stop]
For example:
MPX200 #> miguser begin
Password : *********
MPX200 (miguser) #>
MPX200 (miguser) #> miguser stop
MPX200 #>
Commands
Table 34 lists by type the DMS commands used in the CLI, and provides a cross-reference to the
details for each one.
Table 34 CLI commands
CommandsCommand type
“set system” on page 299
“set features” on page 300
“set fc” on page 301
“set array” on page 302
“set VPGroups” on page 303
set
“migration_group add” on page 304
“migration_group remove” on page 305
“migration_group edit” on page 306
“migration add” on page 307
“migration rm” on page 309
“migration stop” on page 310
“migration start” on page 311
“migration pause” on page 312
“migration resume” on page 313
“migration acknowledge” on page 314
migration
“start_serial_jobs” on page 315
start
“compare_luns add” on page 316
“compare_luns rm” on page 318
“compare_luns stop” on page 319
“compare_luns start” on page 320
“compare_luns pause” on page 321
“compare_luns resume” on page 322
“compare_luns acknowledge” on page 323
compare_luns
MPX200 Multifunction Router 297
To Next Page
Loading...
Need help?
General