FC processor receive sequencer code load
failed.
FatalFC
#%d: QLInitializeAdapter:
Load ISP2322 receive se-
quencer code failed
102658
FC processor transmit sequencer code load
failed.
FatalFC
#%d: QLInitializeAdapter:
Load ISP2322 transmit se-
quencer code failed
102659
FC processor firmware checksum failed.FatalFC
#%d: QLInitializeAdapter:
Verify Checksum command
failed (%x)
102662
FC processor firmware initialization failed.FatalFC
#%d: QLInitializeFW:
FAILED
102680
FC processor paused due to internal parity
error.
FatalFC
#%d: QLInterruptService-
Routine: Risc pause %x
with parity error hccr
%x, Disable adapter
102688
FC processor returned an invalid interrupt
status.
FatalFC
#%d: QLInterruptService-
Routine: Invalid inter-
rupt status: %x
102689
FC processor system error.FatalFC
#%d: QLIsrEventHandler:
System error event (%x),
MB1=%x, MB2=%x, MB3=%x,
MB4=%x, MB5=%x, MB6=%x,
MB7=%x
102716
Response queue entry contains an invalid
handle.
FatalFC
#%d: QLProcessRespon-
seQueue: Invalid handle
%x, type %x
102746
FC processor external SRAM parity error count
exceeded limit; FC port disabled.
FatalFC
#%d: QLTimer: Ext Ram
parity error exceed limit
cnt 0x%x, limit 0x%x,
Disabled adapter
102752
FC processor heartbeat failed.FatalFC
#%d: QLTimer: Heartbeat
failed
102755
FC processor being restarted.`FatalFC
#%d: QLRestartRisc: re-
start RISC
102800
FC processor received a SCSI command for
an unknown target path or has run out of re-
sources to execute additional commands.
ErrorFC
#%d: QLUtmReceiveIo: Path
invalid/FW No resource
count %x
106583
FC processor was disabled by an IOCTL re-
quest to the driver.
ErrorFC
#%d: QLIoctlEnable: Ad-
apter disabled
106589
FC processor firmware failed initialization. The
request to initialize was received by the driver
in an IOCTL request.
ErrorFC
#%d: QLIoctlEnable: Ini-
tialize FW error
106590
FC processor failed the external loopback test.ErrorFC
#%d: QLIoctlRunDiag: Dia-
gnostic loopback command
failed %x % %x %x
106592
MPX200 Multifunction Router 219
To Next Page
Loading...
