To Next Page

To Previous Page

69MSA1000 Installation Guide

Configuration Procedures -

for NetWare Environments

Deploying the MSA1000 in a NetWare environment involves:

1. Installing the HBA Driver on your NetWare Servers

2. Identifying the Server and Operating System to the MSA1000

3. Configuring the Storage Arrays and Logical Volumes

These procedures are discussed in the following paragraphs.

Note: Because the Command Line Interface (CLI) is included in the MSA1000 firmware

and the supported version of the ACU is the bootable version, there are no installation

procedures to prepare for storage configuration.

Prerequisites

■ All equipment must be connected correctly, as detailed in the previous

sections in this document and the HP StorageWorks Modular Smart Array

1000 Configuration Overview poster, included in the shipping carton with the

MSA1000.

■ Host computer must be running a supported version of Novell NetWare.

For a a current listing of the supported NetWare versions, see the MSA1000

website at

http://www.hp.com/go/msa1000

■ Host computer must have all ProLiant server drivers installed from the latest

SmartStart for Servers CD.

Note: See the MSA1000 website at

http://www.hp.com/go/msa1000

for a current list

of system requirements and options.

Other manuals for HP StorageWorks MSA1000

Questions and Answers:

Need help?

Do you have a question about the HP StorageWorks MSA1000 and is the answer not in the manual?

General

RAID levels	0, 1, 0+1, 5
Certification	Microsoft Cluster Server Certification\\r Hewlett Packard Data Protector\\r VERITAS Backup Exec and NetBackup\\r Legato NetWorker for Windows\\r Computer Associates BrightStor Enterprise Backup
Internal memory	256 MB
Memory clock speed	- MHz
Internal memory type	-
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	10 - 90 %
Supported storage drive interfaces	SCSI
Windows operating systems supported	Yes
Harmonized System (HS) code	84733080