89MSA1000 Installation Guide
A
Regulatory Notices
Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification, your
HP StorageWorks Modular Smart Array 1000 is assigned an HP Series number.
The Series number can be found on the product label, along with the required
approval markings and information. The product label is located on the right side
of the chassis. When requesting certification information for this product, always
refer to this Series number. This Series number should not be confused with the
marketing name or model number for your Storage System.
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area may cause harmful interference,
in which case the user must correct the interference at personal expense.
Modifications
The FCC requires the user to be notified that any changes or modifications made
to this device that are not expressly approved by Hewlett-Packard Company may
void the user's authority to operate the equipment.
Cables
Connections to this device must be made with shielded cables with metallic
RFI/EMI connector hoods in order to comply with FCC Rules and Regulations.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
