Table 19 RAID Manager error codes for Continuous Access Journal (continued)
Error contentError code (SSB2)Error code (SSB1)
Cnt Ac-J Paircreate cannot be performed because the mirror ID is invalid.B902B901/B9E0/B9E1/
B9E2/B9E4/D004
The command was rejected because the volume status was SMPL.B907
The S-VOL hide mode is not supported.B90A
Cnt Ac-J Paircreate cannot be performed because the Cnt Ac-J program
product is not installed.
B90D
Cnt Ac-J pair cannot be suspended because the mirror ID is invalid.B909
A status of Cnt Ac-J pair was acquired at the time of unavailable to use the
Cnt Ac-J during the power-on. Retry the operation.
B900
The command was rejected because the Cnt Ac-J configuration was
changed. Check the status of the Cnt Ac-J pair.
B94B
A request of Cnt Ac-J Paircreate was rejected because the consistency group
number is wrong.
B90B
A request of Cnt Ac-J Paircreate was rejected because the path is not set
between the systems.
B90E
A request of Cnt Ac-J Paircreate on the Cnt Ac-J intermediate volume was
rejected because either Cnt Ac-J Z or Cnt Ac-S Z was not installed.
B90F
The settings of the journal option could not be updated.B910
A request of Cnt Ac-J Paircreate or Pairresync was rejected because the
system configuration does not allow these operations.
B913
The command was rejected because no journal was registered.B912/B9F8
A request of Cnt Ac-J pair status transition was rejected because the status
for the request could not be transited. (ex. Status transition other than SMPL
when the Paircreate was requested, or other than PSUS when the Pairresync
was requested.)
DB02
A request of Cnt Ac-J Pair status transition was rejected because the pair
was in the state of Suspending or Deleting.
DB03
Cnt Ac-J pair status cannot be transited during the power-on processing.DB07
114 Troubleshooting
To Next Page
Loading...
Need help?
General