Figure 80 Access holes for the right and left magazines
Right magazine release1.
Left magazine release2.
3. To manually release magazines, insert the end of a small metal pin or straightened paper
clip into the appropriate magazine access hole at the back of the device about 1.5 cm (0.6
inch), while another person grasps the magazines on that side and pulls them out of the
front of the unit. For the MSL4048, MSL8048, and MSL8096, all magazines on a side are
released and should be removed at the same time. See Figure 81 (page 146).
Figure 81 Releasing the magazine
Push a paper clip into the access hole.1.
Pull the magazine out of the front of the unit.2.
IMPORTANT: Do not force the pin once you encounter resistance. Doing so can damage
the device.
4. Repeat step 3 for the other magazine if necessary.
5. If other tapes are still in the device, or if you were unable to manually remove the magazines
and drive, contact Hewlett Packard Enterprise customer service for further instructions.
The wellness test
The wellness test exercises all library and tape drive hardware, except the external connections,
and is useful for verifying that a device is working correctly. The wellness test requires operator
interaction with the mailslot so cannot be initiated from the RMI.
For complete testing, enable the mailslot and ensure that each top-row corner slot contains a
tape cartridge.
146 Troubleshooting
To Next Page
Loading...
Need help?
General
