• SNMP Trap Notification Filter — the types of events for which the device should send SNMP
traps.
• IPv4 or IPv6 Management Station — IP address of the Command View TL management
station. Only one management station can be configured. If both IPv4 and IPv6 IP addresses
are provided, only the IPv4 address will be used
Configuring HPE Systems Insight Manager for the tape library
The library uses the HPE NetCitizen MIB, which is supported by HPE Systems Insight Manager
(SIM) and many other applications. To detect the library using a remote management application,
such as HPE SIM, you must first add the IP address for the management system as an SNMP
target using the network configuration. SNMP queries are only accepted from configured targets.
To configure the library for use with HPE SIM:
1. From the RMI, add the HPE SIM management station as an SNMP target.
2. If the library IP address is in an HPE SIM automatic discovery IP address list, the SIM
management station will detect the library at the next scheduled scan.
To configure HPE SIM for manual discovery:
1. In the HPE SIM toolbar, click Options > Discovery.
2. Click the Manual tab.
3. Enter the library's IP address or system name.
SIM 5.1 will automatically detect the system type and product name.
To manually identify the library with SIM 5.0 and older:
1. In the HPE SIM System and Event Collections pane, click Systems by Type.
2. In the Systems by Type pane, click All systems.
3. Click the link with the IP address or name of the tape library.
4. Click the Tools & Links tab.
5. Click Edit System Properties.
6. Set System Type to Tape Library.
7. Enter the Product Model of your tape library.
8. Click OK.
Changing the administrator password
Use the Configuration > Password page to change the administrator password for the RMI and
OCP.
NOTE: You must set the administrator password with the OCP before you can access
administrator functionality in the RMI. For MSL2024, see Changing the administrator password
(Configuration > Change Admin Password) (page 96). For MSL4048, MSL8048, and MSL8096,
see Changing the administrator password (Configuration > Set Admin Password) (page 124).
Using the RMI 77
To Next Page
Loading...
Need help?
General
