Table 41 Configuration change events (continued)
DescriptionConfiguration eventValue
The world wide identifier base has been changedWorld wide identifier base has been changed0x68
EUI64 identifier has been changedEUI64 identifier has been changed0x69
License key has been added or removedLicense key has been added or removed0x6E
User interface language has changedUser interface language change0x71
Data path failover was enabledDPF enabled0x72
Data path failover was disabledDPF disabled0x73
Control path failover was enabledCPF enabled0x74
Control path failover was enabledCPF disabled0x75
The setting for whether the administrator password
is required to remove magazines or not has been
changed.
Magazine access changed0x76
The setting for whether the Media ID is required
or ignored has been changed.
Ignore barcode Media ID configuration changed0x78
KMIP-based encryption was enabled.KMIP encryption enabled0x7E
KMIP-based encryption was disabled.KMIP encryption disabled0x7F
Information events
Table 42 Informational events
DescriptionInformational eventValue
Move element commandMove element0x01
The inventory was rescannedInventory rescan0x02
Drive cleaning processDrive clean0x03
Open mailslot commandMailslot open0x04
Close mailslotMailslot close0x05
Magazine remove eventMagazine remove0x06
Magazine insertion eventMagazine reinsertion0x07
Power on eventPower on0x08
Power off eventPower off0x09
User login at interface (RMU, OCP, SERIAL)User login0x0A
User logout at interface (RMU, OCP, SERIAL)User logout0x0B
System test runSystem test run0x0C
The wellness test was runWellness test run0x0D
A bus reset occurredBus reset occurred0x0E
Device reset commandDevice reset0x0F
SCSI task abortedAbort0x10
Drive reported informational tape alert flagDrive tape alert flag0x11
182 Troubleshooting
To Next Page
Loading...
Need help?
General
