Regulatory specifications
Table 50 CSA test conditions
Tested condition or valueCharacteristic
Stationary (rack-mount or desk-top)Equipment mobility
Pluggable — Type AConnection to the mains
ContinuousOperating condition
Operator accessibleAccess location
OVC IIOver voltage category (OVC)
-10%, +6%Mains supply tolerance (%) or absolute
mains supply values
NoTested for IT power systems
N/AIT testing, phase-phase voltage (V)
Class IClass of equipment
20 A (branch circuit protection)Considered current rating (A)
PD 2Pollution degree (PD)
IPX0IP protection class
Max 2000Altitude during operation (m)
38Altitude of test laboratory (m)
Max 25 kgMass of equipment (kg)
40 °CManufacturer's Declared Ambient (°C)
NOTE: The CSA test conditions might differ from the product specification limits.
Default and restore defaults settings
You can save the library configuration settings to a file, restore the settings, or reset the library
configuration to the default settings. “Default settings” (page 207) lists the library configuration
parameters, with their default settings and whether they are reset to default or saved to a file.
Table 51 Default settings
Stored in Saved Config
fileReset by Set DefaultsDefault settingParameter
Tape drive settings
YesYesSCSI drive
address
• MSL2024: A full-height tape drive
has SCSI ID 4. The bottom
half-height tape drive has SCSI ID 4
and the top drive has SCSI ID 5.
• MSL4048: All full-height tape drives
have SCSI ID 4. Half-height drive
slots have SCSI ID of 4, 5, 4, 5 from
the bottom up.
• MSL8048 and MSL8096: All tape
drives have SCSI ID 4.
YesYesAutomatic speed, auto port typeFC drive
configuration
Regulatory specifications 207
To Next Page
Loading...
Need help?
General
