EasyManuals Logo

HP StoreEver MSL2024 Service Manual

HP StoreEver MSL2024
220 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #175 background imageLoading...
Page #175 background image
Warning events
Table 40 Warning event codes
Details and SolutionDescriptionEvent code
The application software made an illegal request.
SCSI: transport element full30
SCSI: all slots empty31
SCSI: invalid opcode32
SCSI: invalid element address33
SCSI: invalid field in CDB34
SCSI: invalid drive specified35
SCSI: SEND DIAGNOSTIC command: invalid
test number
36
SCSI: invalid LUN37
SCSI: parameter list length error38
SCSI: parameter list error: invalid field39
SCSI: parameter list error: parameter not
supported
3A
The application software made an illegal request.
SCSI: parameter value invalid3B
SCSI: saving parameters not supported3C
SCSI: invalid ID message3D
SCSI: destination element full3E
SCSI: source slot or drive empty3F
SCSI: wrong checksum40
SCSI: command sequence error41
The application software requested to use a drive
that is disabled. Check the device configuration.
SCSI: drive disabled42
The application software requested to use the
mailslot, but the mailslot is disabled. Check the
device configuration.
SCSI: mailslot disabled43
Check the version of firmware used for the
upgrade. The firmware is incompatible with this
device.
SCSI: flash image does not fit bootcode44
The application software has locked media
removal and either the software or device user
interface attempted to remove the media.
SCSI: media removal prevented by drive45
SCSI: media removal prevented by library46
NOTE: This IS NOT a hardware issue.
If the issue cannot be resolved with the
application software, power off the device,
disconnect the data cable, and then power on the
device.
Check the firmware file used for the upgrade. The
firmware is incompatible with this device.
SCSI: flash image does not fit personality47
The tape drive is not supported by the firmware
in this device. Upgrade the device firmware to the
SCSI: tape drive not supported by this library48
most up-to-date version. Verify that the drive has
Warning events 175

Table of Contents

Other manuals for HP StoreEver MSL2024

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP StoreEver MSL2024 and is the answer not in the manual?

HP StoreEver MSL2024 Specifications

General IconGeneral
Dimensions (WxDxH)87 x 480 x 806 mm
Media typeTape Cartridge
Form factor2U
Product typeStorage auto loader & library
Standard interfacesSerial Attached SCSI (SAS)
Number of slots (max)24
Storage media types supportedLTO-7

Related product manuals