Figure 60 Support > Firmware page
Rebooting the library
Use the Support > Reboot page to do a soft reset of the device, which will run the Power On Self
Test (POST) and scan for a new inventory. The RMI web page will refresh itself after a short time
delay. This time should be sufficient to reload the page. However, during a reboot, the connection
to the device might be lost. If the connection is lost, you will have to reload the page manually.
Figure 61 Support > Reboot page
Viewing logs
From the Support > Library Logs page you can see the device logs. The available logs are: Error
Trace, Informational Trace, Warning Trace, Configuration Change Trace, and Standard Trace.
The log entries are displayed in order of most recent to oldest. The format for the log entries is:
YY.MM.DD HH.MM.SS.ss LIB/ERR<80 89 62 40
• YY.MM.DD — the date displayed as Year.Month.Day
• HH.MM.SS.ss — the time displayed as Hour.Minute.Second.Hundredths of a second
• First code — hard or soft error. The code after LIB/ERR (80 in the example) will be 80 or
40. 80 indicates a hard error, 40 indicates a soft error.
• Second code — the main error code (89 in this example). See Error codes (page 149) for a
list of error codes and recovery procedures.
• Third code — the sub-code (62 in this example). See Error sub-code descriptions (page 166)
for a list of sub-codes.
• Fourth code — sub-code-specific information for factory use only
Using the RMI 85
To Next Page
Loading...
Need help?
General
