Huawei iSitePower-M V100R002C00 - Installing Communications Cables in a Parallel System

(1) Short-circuit plate (2) PDB
----End
8.2.5.4 Installing Communications Cables in a Parallel System
NO TICE
● When installing communications cables in a parallel system, install build-out
resistors at the rst and last modules. The build-out resistors are delivered with
the product.
● The length of a single communications cable cannot exceed 3 m.
● The method of installing communications cables between power modules is the
same as that between battery modules.
Procedure
Step 1 Install communications cables between parallel power modules.
Figure 8-23 Installing communications cables
(1) Build-out resistor
Step 2
Connect the FE ports of the master and slave devices using a network cable.
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1)
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1) 8 Electrical Connection
Issue 01 (2022-07-15) Copyright © Huawei Technologies Co., Ltd. 95