6 Setting the DIP Switch
● If the DIP switch settings are incorrect, the parallel function will fail. Ensure
that correct DIP switches are set.
● The address DIP switch takes eect only after the device is restarted. Set the
address DIP switch before powering on a device.
● Pin 1 (M/S) indicates whether the product is a master or slave. When Pin 1 is
set to ON, the product is a master product. Otherwise, the product is a slave
product. Pins 2–4 (A–C) indicate the high-speed CAN communication addresses
in a parallel system.
● When only one product is used, set Pin 1 to ON.
● The default address is 0 (Pin 1 to Pin 4: OFF).
Step 1 Open the power module maintenance compartment.
Figure 6-1 Open maintenance compartment
Step 2 Set the DIP switch address.
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1)
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1) 6 Setting the DIP Switch
Issue 01 (2022-07-15) Copyright © Huawei Technologies Co., Ltd. 60
To Next Page
Loading...
