11.4 Removing Power Terminals
There are three methods of using the cable removal tool. Select a proper method
based on the actual situation.
Figure 11-1 Usage of the removal tool
(1) Power parallel port for
battery modules
(2) Battery cascading port (3) PV input port
11.5 Power-On
Do not touch the manual ON/OFF switch during the installation. Otherwise,
electric shocks may occur.
11.6 SOC Changes
How does the SOC change from 99% to 100% when the battery is about to be
fully charged?
When the SOC is greater than 99%, the battery switches to
oat charging and the
charge current decreases gradually until the SOC reaches 100%.
11.7 Checking Cable Connections when the Product
Fails to Be Upgraded
If the product fails to be upgraded, check the cable connections. Ensure that the
cables are correctly connected and perform the upgrade again.
11.8 WiFi QR Code Scanning
Scan the QR code on the device to connect to the WiFi. If the connection fails,
contact your installer.
11.9 Querying the Battery Capacity in the Parallel
System Scenario
Query the total system capacity on the app.
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1)
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1) 11 FAQs
Issue 01 (2022-07-15) Copyright © Huawei Technologies Co., Ltd. 178
To Next Page
Loading...
