Huawei iSitePower-M V100R002C00 - Installing the Grid Detection Cable of the ATS

Figure 8-78 Installing genset control signal cables
----End
8.6.7 Installing the Grid Detection Cable of the ATS
NO TICE
In the genset-grid scenario, the automatic transfer switch (ATS) must support the
grid detection function. Connect the grid detection cable of the ATS to the dry
contact port DIN1/port DIN2.
Procedure
Step 1 Install the grid detection cable of the ATS.
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1)
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1) 8 Electrical Connection
Issue 01 (2022-07-15) Copyright © Huawei Technologies Co., Ltd. 147