Huawei iSitePower-M V100R002C00 - Preparing Cables and Terminals; Preparing a Cord End Terminal; Preparing an OT Terminal

B Preparing the Cable and Terminal
B.1 Preparing a Cord End Terminal
Figure B-1 Preparing a cord end terminal
(1) Cable
(2) Cord end terminal (3) Crimping tool
B.2 Preparing an OT Terminal
NO TICE
● Avoid scratching the core wire when stripping a cable.
● The cavity formed after the conductor crimp strip of the OT terminal is crimped
must wrap the core wires completely. The core wires must contact the OT
terminal closely.
● Wrap the wire crimping area with heat shrink tubing or insulation tape. The
heat shrink tubing is used as an example.
● When using a heat gun, protect the equipment from being scorched.
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1)
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1) B Preparing the Cable and Terminal
Issue 01 (2022-07-15) Copyright © Huawei Technologies Co., Ltd. 185