Huawei iSitePower-M V100R002C00 - Battery Storage and Recharge

Alarm Name Alarm
Severity
Causes Suggestion
Overtemperatu
re
Major The temperature
is high inside the
module.
1. Power o and then power
on the module. Check whether
the alarm is cleared. If yes, no
further action is required. If no,
go to the next step.
2. Contact Huawei technical
support to check the module
and return it to the factory for
repair.
Hardware Fault Major The EEPROM in
the power
module is faulty,
DSP2 redundancy
protection is
triggered, or the
PFC is faulty.The
EEPROM in the
power module is
faulty, DSP2
redundancy
protection is
triggered, or the
PFC is faulty.
1. Power o and then power
on the module. Check whether
the alarm is cleared. If yes, no
further action is required. If no,
go to the next step.
2. Contact Huawei technical
support to check the module
and return it to the factory for
repair.
Communicatio
n Failure
Major The
communications
cable between
the SMU and the
module is loose.
1. Power o and then power
on the module, and check
whether the module running
information is normal.
If yes, no further action is
required.
If no, contact Huawei technical
support.
Module
Upgrade
Failure
Major The system
experiences a
power failure
during an
upgrade.
1. Upgrade the power module
again and check whether the
alarm is cleared. If yes, no
further action is required.
10.4 Battery Storage and Recharge
Battery Acceptance Inspection
A battery recharge label must be put on the battery packing case to indicate the
latest charge time.
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1)
iSitePower-M V100R002C00 User Manual
(MAP05A1, MAB05B1) 10 System Maintenance
Issue 01 (2022-07-15) Copyright © Huawei Technologies Co., Ltd. 172