Huawei UA5000 - Page 106

Device or Port Item Data
Name of the host that generates the
trap
public
iManager U2000 IP address 10.10.1.1/24
Default gateway 10.10.1.10/24
NMS name huawei
GET community name public
SET community name private
Procedure
l Configure the inband NMS on the UA5000 side.
1. Configure the IP address of the inband NMS interface.
huawei(config)#interface eth
huawei(interface-eth)#ip address 10.20.1.3 255.255.255.0 10.20.1.1
vlan_tag 1001
2. Configure the community name and the access authority.
huawei(config)#snmp-agent community read public
huawei(config)#snmp-agent community write private
3. Enable the trap sending.
huawei(config)#snmp-agent trap enable standard
4. Configure the trap destination host name, IP address, and trap sending parameter list
name.
huawei(config)#snmp-agent target-host trap-hostname public address
10.10.1.10 trap-paramsname public
huawei(config)#snmp-agent target-host trap-paramsname public v2c
securityname public
5. Save the data.
huawei(config)#save
l Configure the inband NMS on the iManager U2000 side.
1. Set the following parameters on the iManager U2000.
– IP address: 10.10.1.1.
– GET community name: public
– SET community name: private
2. Configure the route gateway to subnet 10.20.1.0/24 as 10.10.1.10.
NOTE
When the IP address of the inband NMS interface is not in the same subnet of the iManager
U2000, you need to configure the route for forwarding the IP packets.
----End
Result
You can maintain and manage the UA5000 through the iManager U2000.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 4 Commissioning the Interconnection
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
98