Flowchart
Figure 3-10 shows the flowchart for logging in to the UA5000 in the local serial port mode
Figure 3-10 Flowchart for logging into the UA5000 in the local serial port mode
Procedure
Step 1 Use a standard RS-232 serial port cable to connect the serial port on the PC to the COM port on
the PVMB control board, as shown in Figure 3-9.
Step 2 Configure the HyperTerminal communication parameters.
NOTE
The following considers the typical mode in Windows as an example to describe how to log in to the system
in the local serial port mode. Other modes are not described here.
1. Set up a connection.
Choose Start > Programs > Accessories > Communications > HyperTerminal on the
PC to display the Connection Description dialog box. Enter the connection name, and
then click OK, as shown in the following figure.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
28
To Next Page
Loading...
