Huawei UA5000 - Page 47

Prerequisites
l You must log in to the UA5000 through the local serial port and the IP address and the
subnet mask must be configured for the UA5000. For detailed configuration, see 3.5.1
Login in the Local Serial Port Mode.
l The IP address of the maintenance terminal has been correctly configured. For the process
of configuring the IP address for the maintenance terminal, see Configuring the IP Address
of the Maintenance Terminal.
NOTE
In the following operations, the configuration of the UA5000 must be performed through the local serial
port.
Networking — Inband Management over a LAN
Figure 3-19 shows the example network for configuring the inband management over a LAN
in SSH mode.
Figure 3-19 Example network for configuring the inband management over a LAN in SSH mode
PC3
PC1
LAN
PC2
UA5000
ETH1
COM
0/4/0
PVMB
ETH0
Networking — Inband Management over a WAN
Figure 3-20 shows the example network for configuring the inband management over a WAN
in SSH mode.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
39