Huawei UA5000 - Page 57

Prerequisites
l You must log in to the UA5000 through the local serial port and the IP address and the
subnet mask must be configured for the UA5000. For detailed configuration, see 3.5.1
Login in the Local Serial Port Mode.
l The IP address of the maintenance terminal has been correctly configured. For the process
of configuring the IP address for the maintenance terminal, see Configuring the IP Address
of the Maintenance Terminal.
NOTE
In the following operations, the configuration of the UA5000 must be performed through the local serial
port.
Networking — Outband Management Interface over a Local Area Network
Figure 3-29 shows the example network for configuring the outband management over a LAN
in SSH mode.
Figure 3-29 Example network for configuring the outband management over a LAN in SSH
mode
PC3
PC1
LAN
PC2
UA5000
ETH1
COM
0/4/0
PVMD
ETH0
Networking — Outband Management over a Wide Area Network (WAN)
Figure 3-30 shows the example network for configuring the outband management over a WAN
in SSH mode.
Figure 3-30 Example network for outband management over a WAN in SSH mode
UA5000
ETH1
COM
0/4/0
Router
PC
PVMD
ETH0
10.10.20.10/24
10.10.1.0/24
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
49