Huawei UA5000 - Page 60

l If you log in to the UA5000 through the outband management over a WAN in SSH mode,
set up a network environment according to the networking shown in Figure 3-30.
Step 2 Configure the IP addresses of the maintenance network port.
In outband mode, you can run the ip address command to configure the IP address of the
maintenance network port.
huawei(config)#interface outband
huawei(interface-outband)#ip address 10.10.20.10 255.255.255.0 10.10.20.1 vlan_tag
1
huawei(interface-outband)#exit
Step 3 Create a user.
Add a user. The profile is operator, the user name and the password are huawei1, the level is
operator, and the number of times for login is 4.
huawei(config)#terminal user name
User profile name(<=15 chars)[root]:operator
User Name(<=15 chars):huawei1
User Password(<=15 chars):
Confirm Password(<=15 chars):
User's Level:
1. Common User 2. Operator 3. Administrator:2
Permitted Reenter Number(0--4):4
User's Appended Info(<=30 chars):
This user has been added
Repeat this operation? (y/n)[n]:n
Step 4 Create the local RSA key pair.
Run the rsa local-key-pair create command to create the local RSA key pair.
CAUTION
To log in to the system in SSH mode successfully, you need to configure and create the local
RSA key pair first. Before performing other configurations in SSH mode, create the local key
pair in SSH mode.
huawei(config)#rsa local-key-pair create
The key name will be: Host
% RSA keys defined for Host already exist.
Confirm to replace them? [y/n]:y
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Input the bits in the modulus[default = 512]:
Generating keys...
.....++++++++++++
....++++++++++++
.......................++++++++
........++++++++
Step 5 Set the SSH user authentication mode.
Run the ssh user authentication-type rsa command to select the SSH user authentication mode.
The SSH user authentication mode is classified into the following four types and the rsa
authentication mode is considered as an example here.
l password: The common password is used for authentication.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
52