18 2. Balancing Overview GSP9700 Series Road Force Measurement System Operation
2.2 Identifying the Static Balance Weight Plane
In “STANDARD BALANCE” mode, using only a clip-on weight, the plane is input as
follows:
For static balancing, it is recommended that you place half of the correctional weight
value on each side of the tire to reduce residual dynamic imbalance.
In “MIXED WEIGHTS BALANCE” mode and “ADHESIVE WEIGHTS BALANCE”
mode, using an adhesive weight, the plane is input as follows:
DIAMETER
For static balancing, it is recommended that the adhesive weight be placed as close
to the center of the wheel as possible to reduce residual dynamic imbalance.
In “PATCH BALANCE” mode, using a patch weight, the plane is input as follows:
DIAMETER
For static balancing, it is recommended that the patch weight be placed as close to
the center of the tread as possible to reduce residual dynamic imbalance.
To Next Page
Loading...
