GSP9700 Series Road Force Measurement System Operation 6. Equipment Information 103
6. Equipment Information
6.1 Software Identification
Selecting “Identify Software” from the logo screen will display the software version,
and all installed features and trademarks.
6.2 Program Cartridge Removal and Installation
CAUTION: Only a Hunter authorized service representative should
perform this procedure. A static wrist strap should be worn to
prevent damage to static sensitive parts.
NOTE: Customer settings should be recorded prior to cartridge
replacement.
Turn the unit power “OFF” and disconnect the AC power cord from the power source.
Remove the two Phillips screws securing the access panel to the rear of the CRT
support console and remove the access panel.
To Next Page
Loading...
