GSP9700 Series Road Force Measurement System Operation 4. Balancing a Wheel 37
Switching from SmartWeight™ to Traditional Dynamic Balancing Modes
At any time, SmartWeight can be switched to standard balancing as long as both
standard and SmartWeight modes are enabled in setup.
On units with a control knob, press the knob until SmartWeight is highlighted. Once
highlighted, press and hold the knob till the standard balance icons appear. Cycle
back the same way.
On units without the control knob select the “Disable SmartWeight” button on the
balance screen.
Dynamic Balancing Selection
Dynamic balancing is selected by pointing the indicator to while rotating the
control knob. Dynamic will always display two weight planes.
Dynamic balancing provides a more complete balance than static balancing.
Dynamic balancing should be selected whenever possible to minimize vehicle
vibration. Refer to “Dynamic Imbalance,” page 16.
Static Balancing Selection
Static balancing is selected by pointing the indicator to while using the control
knob. Static balancing provides a less desirable balance than dynamic balancing.
Dynamic balancing should be selected whenever possible to minimize vehicle
vibration. Refer to “Static Balance,” page 15.
To Next Page
Loading...
