Hunter GSP9712 - MIXED WEIGHTS Balancing Procedure (Combination of Clip-On & Adhesive Weights)

GSP9700 Series Road Force Measurement System Operation 4. Balancing a Wheel  41
Attach the weight amount shown on the CRT for the right weight plane to the outer
rim of the wheel.
If necessary, use the right “ ” to split the weight. Refer to “Split Weight
®
Feature,” page 87.
Verify balance condition by spinning again with the load roller disabled. Refer to
“Load Roller Operation,” page 60.
Left and right weight plane displays should show “zero.”
STANDARD balancing procedure is complete.
MIXED WEIGHTS Balancing Procedure
(Combination of Clip-On & Adhesive Weights)
Verify that the wheel is clean and free of debris.
Remove all previous weights.
Mount tire/wheel assembly. Refer to “Mounting the Wheel,” page 23.
Press “
.”
Use the arrows to select “MIXED WEIGHTS BALANCE” and press “OK.”
Select either grams or ounces by rotating the control knob and highlighting either “g”
or “oz.”
Select “DYNAMIC” by rotating the control knob to highlight “
.” Refer to “Dynamic
Balancing Selection,” page 37.