12 1. Getting Started GSP9700 Series Road Force Measurement System Operation
Primary Balancing Display
Using the Control Knob (GSP9712)
The control knob is located to the right of the softkeys. The control knob is used to
control the on-screen switches and manually input data. The on-screen switches that
are available are dependent upon the setup configuration of the balancer.
CONTROL
KNOB
K4 KEY
K3 KEY
K2 KEY
K1 KEY
MENU
SHIFT
KEY
START
KEY
STOP
KEY
RESET
KEY
CONTROL KNOB ACCESSED ON-SCREEN SWITCHES
Pushing in on the control knob cycles through the on-screen switches that are available
on the current primary screen. Rotating the control knob clockwise or counter-clockwise
changes the setting for the selected on-screen switch.
For example, in the “Balance” primary screen, pushing in on the control knob will cycle
through the grams to ounces, the static and dynamic, and the load roller on-screen
switches. After selecting an on-screen switch, the setting may be selected by rotating
the control knob. The “selected” switch is the one showing the hand.
To Next Page
Loading...
