GSP9700 Series Road Force Measurement System Operation 2. Balancing Overview 19
2.3 Identifying the Dynamic Balance Weight Planes
The balancer must know the location of the two weight circle planes for placement of
correction weights on the wheel assembly.
Each plane is described by a distance from the balancer and a diameter.
MIXED WEIGHTSSTANDARD PATCHADHESIVE WEIGHTS
RIM LIP / RIM LIP RIM LIP / INNER RIM SURFACE
INNER RIM SURFACE /
INNER RIM SURFACE
INNER TIRE SURFACE /
INNER TIRE SURFACE
In “STANDARD BALANCE” mode, using only clip-on weights, left and right planes
are input as follows:
In “MIXED WEIGHTS BALANCE” mode, using clip-on and adhesive weights, the left
and right planes are input as follows:
In “ADHESIVE WEIGHTS BALANCE” mode, left and right planes are input as
follows:
To Next Page
Loading...
