Hunter GSP9712 - 3 Mounting Wheels on the Balancer; Mounting the Wheel Using Wheel Lift (Optional); Raising the Tire;Wheel Assembly

GSP9700 Series Road Force Measurement System Operation 3. Mounting Wheels on the Balancer  21
3. Mounting Wheels on the Balancer
3.1 Mounting the Wheel Using Wheel Lift (Optional)
The Wheel Lift is an optional feature on the GSP9700 series balancer. For
instructions on mounting the tire/wheel assembly without the optional wheel lift, refer
to “Mounting the Wheel,” page 23.
Raising the Tire/Wheel Assembly
Press the lift control handle “down” until the trolley carriage is at its lowest level.
Slide the appropriate mounting cone onto the spindle.
LIFT CONTROL
HANDLE
DOWN
UP
With the trolley carriage extended all the way out to the right, roll the tire/wheel
assembly onto the trolley carriage.
TROLLEY
CARRIAGE
Raise the lift control handle “up” to move the lifting beam and trolley into a position
where the tire/wheel assembly can be installed onto the spindle.