22 3. Mounting Wheels on the Balancer GSP9700 Series Road Force Measurement System Operation
Slide the tire/wheel assembly onto the spindle and center on the mounting cone.
Verify that the tire/wheel assembly is centered vertically on the spindle. Refer to
“Mounting the Wheel,” page 23.
TIRE/WHEEL
SSEMBLY CENTERED
VERTICALLY ON
SPINDLE
SPINDLE
Install the clamping cup and wing nut on the spindle shaft against the wheel and
secure the entire assembly by firmly tightening the wing nut, while depressing the
foot pedal to hold the spindle in place.
With the tire/wheel assembly secured to the GSP9700, press the lift control handle
“down” until the trolley carriage is at its lowest level.
NOTE: The trolley carriage will also retract to its lowest level
automatically when the hood is closed.
Service the tire/wheel assembly as necessary. Refer to “Balancing a Wheel,” page 35
for specific operation instructions.
To Next Page
Loading...
