GSP9700 Series Road Force Measurement System Operation 3. Mounting Wheels on the Balancer 29
The pressure ring should be used to prevent the wing nut from directly contacting an
adaptor or a cone. It will act as a bearing to enable higher clamping forces.
Spacers
Hub Ring Spacers
These light truck spacers are designed to build a larger pocket when using extra
large truck cones. It also provides a location for the centering pins found on some
dual wheel configurations.
Shaft Spacers
The shaft spacer can be used to make the cone contact the hub bore more firmly.
For example, one cone size is too small because the captivated spring is not
pressing the cone against the inner wheel opening, but the next larger cone size is
too large and will not fit the opening. Use the smaller cone size, with the spacer, to
extend the captivated spring and hold the smaller mounting cone against the wheel
opening with greater pressure.
To Next Page
Loading...
