GSP9700 Series Road Force Measurement System Operation 4. Balancing a Wheel 67
QuickMatch™ Procedures
To correct loaded runout by QuickMatch™:
Rotate the tire loaded runout high spot on the wheel to TDC, or with the hood
in the raised position and the servo enabled, press “START.” Mark the tire
with a piece of chalk or a marker at TDC.
Rotate the rim low spot on the wheel to TDC, or with the hood in the raised
position and the servo enabled, press “START.” Mark the rim with a piece of
chalk or a marker at TDC.
Use a tire changer and align the tire and rim marks to one another. Refer to
the operation instructions for the tire changer in your shop.
NOTE: If the wheel assembly can be corrected by QuickMatch, the
results can be viewed prior to removing the assembly from
the balancer by viewing the “Current QuickMatch
Measurements” primary screen.
QuickMatch™ is complete.
To Next Page
Loading...
