GSP9700 Series Road Force Measurement System Operation 4. Balancing a Wheel 45
With the servo enabled, attach the adhesive weight for the right weight plane using
the weight amount shown on the CRT. Refer to “Servo-Aided Adhesive Weight
Placement,” page 51. If servo is not enabled, BDC placement should be used. Refer
to “Manual Weight Position Measurement,” page 48.
BDC
SERVO-AIDED
ARM CONTACT POIN
If necessary, use the right “ ” to split the weight. Refer to “Split Weight
®
Feature,” page 87.
Verify balance condition by spinning again with the load roller disabled. Refer to
“Load Roller Operation,” page 60.
Left and right weight plane displays should show “zero.”
ADHESIVE WEIGHTS balancing procedure is complete.
PATCH BALANCE
®
Procedure
Weighted balance patches will be placed on the inside of the tire at the edge of the
tread area beside the sidewall as shown below:
LEFT PLANE
RIGHT PLANE
INTERNAL DIAMETER
NOTE: Weighted balance patches should be installed only in tread
area. Do not install weighted balance patches near sidewall
or shoulder of tire.
To Next Page
Loading...
