GSP9700 Series Road Force Measurement System Operation 1. Getting Started 7
Specific Precautions/Power Source
The GSP9700 is intended to operate from a power source that will apply 230 volts
(208 - 240), 1 phase, 50/60 Hz between the supply conductors of the power cord.
The power cord supplied utilizes a twist lock connector, NEMA L6-20P. This machine
must be connected to a 20 amp branch circuit. Please refer all power source issues
to a certified electrician. Refer to “Installation Instructions for GSP9700 Series Road
Force Measurement System,” Form 4203T (for GSP9702) or “Installation
Instructions for GSP9712 Series Road Force Measurement System,” Form 4972T
(for GSP9712).
CAUTION: A protective ground connection, through the grounding
conductor in the power cord, is essential for safe operation.
Use only a power cord that is in good condition.
Turning Power ON/OFF
The ON/OFF switch is located on the back of the balancer cabinet. To turn the
balancer “ON,” press the “I” side of the ON/OFF switch. To turn the balancer “OFF,”
press the “O” side of the ON/OFF switch.
The system requires only a few seconds to “boot up.” During “boot up,” the system
will generate a high-pitched tone until the software is loaded and running.
After the GSP9700 performs a self-check, the “Logo” screen will appear indicating
the unit is ready for use.
To Next Page
Loading...
