62 4. Balancing a Wheel GSP9700 Series Road Force Measurement System Operation
ForceMatching™ Procedures
To correct road force by ForceMatching™:
Rotate the tire road force high spot on the wheel to TDC, or with the hood in
the raised position and the servo enabled, press “START.” Mark the tire with
a piece of chalk or a marker at TDC. If desired, mark the tire with the
ForceMatch Code. Refer to “Using ForceMatch Codes Feature,” page 64.
NOTE: When the wheel is rotated to TDC, the chalk will appear
green on the console display and the tire ForceMatch Code
will appear in the tire tread.
TIRE
FORCE VARIATION
HIGH SPOT MARK
INDIVIDUAL
RIM HIGH SPOTS
TIRE/WHEEL
ASSEMBLY
FORCE VARIATION
HIGH SPOT
TIRE
FORCEMATCH CODE
Rotate the rim low spot on the wheel to TDC, or with the hood in the raised
position and the servo enabled, press “START.” Mark the rim with a piece of
chalk or a marker at TDC. If desired, mark the rim with the ForceMatch Code.
Refer to “Using ForceMatch Codes Feature,” page 64.
NOTE: When the wheel is rotated to TDC, the chalk will appear
green on the console display and the rim ForceMatch Code
will appear between the rim lips.
RIM
FORCEMATCH CODE
RIM AVERAGE
LOW SPOT
To Next Page
Loading...
