80 4. Balancing a Wheel GSP9700 Series Road Force Measurement System Operation
4.13 Blinding and Rounding
If traditional balancing method is selected, the balancer can display either an “actual”
or “blinded and rounded” amount of imbalance.
“Blind” is a tolerance or amount of imbalance required before an imbalance amount is
displayed. “Round” allows the balancer to display weight imbalance to a desired
increment. The blind and round values can be changed in the “Setup” procedure.
Refer to “Service Mode Setup and Features,” page 111.
While in the “Balance” primary screen, blind and rounding may be disabled by
rotating the control knob to highlight “
”. The actual amounts of imbalance for the
selected mode will be displayed when “Blind and Rounding” are disabled as shown
below.
“BLIND AND
ROUNDING”
DISABLED
NOTE: SmartWeight™ balance method does not utilize a disabling
feature for weight blinding. A disabled weight blinding feature
is not necessary with SmartWeight and eliminates the need
for this feature.
To Next Page
Loading...
