GSP9700 Series Road Force Measurement System Operation 4. Balancing a Wheel 49
Measuring Dimensions for Standard Clip-on Weight Balancing
To measure rim dimensions for clip-on weights, activate the Standard balancing
mode. Pull the inner Dataset
®
arm away from the weight tray and UPWARD until it is
touching the top of the wheel inner rim lip. Simultaneously pull the outer Dataset
®
arm out and upward until it is touching the top of the wheel outer rim lip. While the
Dataset
®
arms are in place, depress the foot pedal to enter the dimensional data. The
GSP9700 will beep to confirm data entry.
NOTE: Dataset
®
arms can input dimensions separately if desired.
Measuring Dimensions for Mixed Weights (Clip-on/Tape-on) Balance
To measure rim dimensions for the clip-on weight, pull the inner Dataset
®
arm away
from the weight tray and UPWARD until it is touching the wheel inner rim lip. Depress
the foot pedal to enter the dimensional data. The GSP9700 will beep to confirm data
entry.
Do NOT return the Dataset
®
arm to the home position.
Move the Dataset
®
arm DOWNWARD until the roller disk edge is touching the wheel
at the right edge of the desired adhesive weight location. Depress the foot pedal to
enter the dimensional data. The GSP9700 will beep to confirm data entry.
To Next Page
Loading...
