Hunter GSP9712 - Split Weight Feature; Split Weight Operation

GSP9700 Series Road Force Measurement System Operation 5. Balancing Features and Options  87
The Inflation Station screen exits automatically when you remove the hose from the
valve stem, or if you manually exit via the softkeys.
For safety, spinning is prevented for any of the following conditions: When the
Inflation Station screen is showing, the hose is not at the storage position, or the
hose is pressurized (not disconnected from the valve stem).
5.9 Split Weight
®
Feature
Press “ ” to change the required imbalance correction weight amount into two
smaller size weights. The angle is adjusted by the balancer to produce the non-
rounded correction called for by the single weight before split. This provides exact
imbalance correction without weight trimming. The non-rounded imbalance is split
regardless of whether blind and rounding are enabled. For this reason, Split Weight
®
is more accurate than applying a single weight with the blind and rounding enabled.
Split Weight
®
is especially useful when the imbalance amount is large or unavailable,
such as 6.0 ounces. Split Weight
®
eliminates the error caused by placing two 3.0
ounce weights side-by-side, which would leave a substantial residual imbalance:
Use “ ” when the weight location interferes with a hubcap or trim ring, when
one weight is too large, to avoid weight trimming, or to substitute for a weight size
that is out of stock.
Split Weight
®
Operation
Each time “ ” is pressed, the two weights are increased to the next largest
weight size and are placed (fanned out) further down the rim, as shown below.
NOTE: To return to the original single weight, you can either toggle
the control knob between static and dynamic, or continue to
split the weight until all choices are exhausted.
Press the green “START” button with the safety hood in the RAISED position and the
GSP9700 will find the first split weight plane.
Attach the appropriate weight as displayed on the console.
Continue pressing “START” with the safety hood in the RAISED position and
attaching the weights until all weights shown on the console have been applied.