58 4. Balancing a Wheel GSP9700 Series Road Force Measurement System Operation
For example, the “CenteringCheck
®
” popup screen pops up over the “Balance”
primary screen. The softkeys change from the primary screen to support the
“CenteringCheck®” operation.
When the operation is complete or has been cancelled/exited, the popup screen
reveals the primary screen from which it appeared.
Notice two very important aspects of this scheme:
The popup screen does not completely “hide” the screen over which it
pops up. It leaves the title bar of the primary screen exposed while the
title bar of the current selection is highlighted.
The popup screen has a softkey menu that supports only the operations
required by that screen. This greatly simplifies the menus of the primary
screens and makes it easier to control the operation of the popup
screens.
Balance Primary Screen
The “Balance” primary screen has a choice of two related views. They are:
Set Dimensions
Apply Weights
By pressing “Set Dimensions” or “Apply Weights,” the primary screen toggles views
of the current operation. The first row menu keys will change to those needed for the
current view, while the second and third row menu keys remain the same.
The “Apply Weights” view is the spinning operation view of the balancer. The Split
Weight
®
softkeys are available in this view on the first row menu. The on-screen
switches change the gram/ounce selection, the dynamic/static (blind/round) selection,
and the load roller enable/disable selection.
To Next Page
Loading...
