Hunter GSP9712 - Smartweight Options - Setting up the Force Limits; Weightsaver Residual Goal; Setting up the Inner Dataset Arm Type

114  6. Equipment Information GSP9700 Series Road Force Measurement System Operation
SmartWeight™ Options - Setting Up the Force Limits
NOTE: The force limits values are set to exact default
measurements and should not be changed except by
qualified personnel for very specific reasons.
Force Limits can be adjusted for the up and down static force and the side-to-side
couple force.
Any changes to the limits can be reset by selecting the “Set Factory Defaults” softkey.
WeightSaver™ Residual Goal
WeightSaver™ residual goal is the percent of the shimmy force limit intentionally left
in the assembly to save weight. A lower value favors lower residual shimmy and a
higher value favors weight savings.
The Residual Goal has a default of 75% of the maximum allowed shimmy force to
maximize weight savings.
Setting Up the Inner Dataset Arm Type
Selects the appropriate dataset arm. Some units will have a fixed length arm, while
others will have an extendable arm for larger diameter rims.