GSP9700 Series Road Force Measurement System Operation 1. Getting Started 11
1.4 Operating the Console
Using Softkeys
The “softkeys,” located on the CRT support console directly beneath the CRT,
provide operator control of the balancer. The keys are identified as:
K1 key
K2 key
K3 key
K4 key
Menu shift key
Start key
Stop key
Reset key
The four menu labels that appear at the bottom of each video screen are referred to
as the “softkey labels.” Each label indicates the action that the program takes when
the corresponding K1, K2, K3, or K4 key is pressed.
The display between the “K2” and “K3” labels indicates how many rows of labels are
available. Most screens have only one or two rows, however more rows are possible.
The green box indicates the row that is currently displayed.
The menu row is changed by pressing the menu shift key,
. When this key is
pressed, the menu labels change to the next row down. If the last row is currently
displayed, the menu labels change to the first row.
Throughout this manual, the statement press “nnnnnnn” means press the softkey
with the label “nnnnnnn.” If the required label is not on the current menu, press
to
change rows until the desired label is displayed.
To Next Page
Loading...
