Hunter GSP9712 - Page 50

42  4. Balancing a Wheel GSP9700 Series Road Force Measurement System Operation
Use both Dataset
®
arms in the UPWARD position at the clip-on weight location to
measure the distance, diameter, and rim width dimensions. Refer to “Using the Auto
Dataset
®
Arms,” page 48.
Do NOT return the arm to the “home” position.
Using the DOWNWARD position, move the inner Dataset
®
arm disk edge to the
location for placement of the right edge of the adhesive weight on the right weight
plane and enter data by depressing the foot pedal. Refer to “Using the Auto Dataset
®
Arms,” page 48.
Close safety hood.
Press the green “START” button if “Hood Autostart” is disabled.
After wheel comes to a complete stop, raise safety hood.
The GSP9700 will find the TDC for the left weight plane if “Servo-Stop” is enabled.
“Servo-Stop” will hold the wheel in the TDC position while the weight is applied.
Attach the clip-on weight amount shown on the CRT for the left weight plane to the
inner rim of the wheel.
If necessary, use the left “ ” to split the weight. Refer to “Split Weight
®
Feature,” page 87.