19
One Touch Manual Start and Advance
You can also activate a program to water without using the dial.
1. Hold down the
button for 2 seconds.
2. This feature automatically defaults to program
A. You can select program B, or C by pressing
the
program.
3. The station number will be flashing. Press the
or button to scroll through the stations
and use the
and buttons to adjust
the station run times. (If no buttons
are pressed during step 2 or 3, the
controller will automatically begin
program A.)
4. Press the
button to scroll to the
station you wish to begin with. After a 2
second pause, the program will begin.
This feature is great for a quick cycle when extra watering is needed or if
you would like to scroll through the stations to inspect your system.
PROGRAMMING THE CONTROLLER (continued) ..............................................................
Pro-C
®
RUN
RAIN SENSOR
BYPASS
ACTIVE
SET CURRENT DATE / TIME
SET PROGRAM START TIMES
SET DAYS TO WATER
SET STATION RUN TIMES
SYSTEM OFF
MANUAL – ALL STATIONS
SET PUMP OPERATION
MANUAL – SINGLE STATION
To Next Page
Loading...
Need help?
General
