Hunter X-CORE User Manual

9
NOTE: Any extension of the wiring on the
SmartPort
®
may result in an error message in
the controller display and possible malfunction
of the remote unit due to radio interference. In
some situations, lengthening of the harness may
work fine, in others it may not work at all (it is
site specific). In either case, extending the wiring
harness should be done using shielded cable to
minimize the possible effects of electrical noise.
For easiest installation, order a new Hunter
SmartPort shielded cable wiring harness (part
#SRR-SCWH) with a full 25 feet of shielded cable.
Controller
Receiver
Outdoor Installation
(Temporary Connection
of Receiver Only)
Indoor Installation
CONNECTING TO THE HUNTER ET SYSTEM
The Hunter ET System allows irrigation programs to be created
automatically, based on local climate conditions. These programs are
then loaded into the controller and run automatically. ET System uses a
sensor to determine the local “evapotranspiration” (ET) rate of turf and
plants. The result is a new, water-efficient irrigation program every water
day, based on local weather conditions. For more information on the ET
System, contact your local Hunter dealer.
ET MODULE
ET SENSOR

Hunter X-CORE Specifications

General

Start Times Per Program	4
Max Station Run Time	4 hours
Warranty	2 years
Application	Residential
Mounting	Wall mount
Station Timing	1 minute to 4 hours
Number of Stations	2, 4, 6, or 8
Watering Duration	1 minute to 4 hours
Display	LCD
Stations	2, 4, 6 or 8 stations
Indoor/Outdoor	Indoor or Outdoor
Seasonal Adjustment	Yes
Watering Days	7 days
Rain Delay	Yes
Power Source	24V AC transformer
Battery Backup	Yes
Programs	3