3
FEATURES
Wireless Rain-Clik
™
sensors attach quickly and easily to your controller. Wireless Rain-Clik
™
features include:
1. Quick Response
™
– Unique technology that
turns off the irrigation system immediately
rather than after it has accumulated a fixed
amount of rain. No calibration is required.
2. Maintenance-Free Design – Provides trouble-
free operation for up to ten years. There are
no batteries to replace.
3. Wireless operation up to 800 ft. (275 m) –
No wires are required between the rain sensor
and controller.
4. Two models available:
Wireless Rain-Clik
™
(WR-CLIK) – Acts as a
switch to deactivate automatic watering of
your irrigation controller when it rains. Once
rain has stopped and the sensor has dried out,
automatic irrigation will resume.
Wireless Rain/Freeze-Clik (WRF-CLIK) – The
Wireless Rain/Freeze-Clik includes a freeze
sensor that is designed to keep the irrigation
system from operating when temperatures
drop to 37˚F or below. When temperatures rise
above 37˚F, the sensor will enable automatic
watering.
5. Automatic Synchronization – The Wireless
Rain-Clik
™
transmitter will send wireless
signals every hour to the receiver to assure
that the sensor and receiver are continuously
synchronized.
6. Lost Communication/Battery Status
Indication – The Sensor Bypass LED will flash
RED if the receiver has not received a signal
from the transmitter. This can indicate a low or
dead battery.
To Next Page
Loading...
Need help?
General
