English – 55
12. Hold the front edge of the cutting deck with both
hands and pull forwards until it stops.
13. Lift the deck up to vertical position until a click
sound is heard. The cutting deck is locked
automatically in the vertical position.
CAUTION: The drive belt can get
pinched and break if gets caught under
the cutting deck. Pull on the drive belt
loop in the belt holder to stretch the
drive belt before you push the cutting deck in.
4. Lift the cutting height stay from the stay holder
and put it in the hole (1).
5. Hold the spring handle and lift the drive belt out of
the holder.
6. Put the drive belt around the tension wheel (2).
Make sure that the drive belt runs as illustrated
below.
7. Pull the spring in the spring holder (3).
8. Pull the auger lever up to operating position
9. Attach the front cover.
Cutting system
Return from service position
1. Hold the front edge of the cutting deck with your
left hand.
2. Release the lock with your right hand.
3. Fold down the cutting deck and push it in until it
stops.
To Next Page
Loading...
Need help?
General
